|
Model
| Stock Ref No
|
|
Trento
| 43 10 15
|
|
EXT100 - External Wall fan
| 43 16 05
|
Overview
A 600mm built in telescopic unit, designed to be mounted in a kitchen cupboard.The unit has a 125mm spigot that can be connected to an external wall fan or a Multivent system.The unit has a telescopic slide, which activates the small 90m³/h fan inside the units that creates the air curtain that surrounds the cooking area, preventing smells and steam from circulating around the kitchen. At the rear of the unit is a manual sliding switch for opening and closing the duct to atmosphere. During cooking the sliding switch must be in the open position.
The external wall fan has a 100mm Ø spigot and can be mounted on the external wall and connected to the System Cooker Hood using 100mm aluminium ducting. The external wall fan can be activated using a fused switch mounted inside the kitchen. When using the external wall fan the hole through the wall must be a minimum of 800mm above the bottom of the hood for allowing ducting connection onto the fan motor for the air curtain.
Dimensions (mm)
Typical Specification
Supply and install a Trento System Cooker Hood as supplied by:
Vent-Axia Clean Air Systems
Fleming Way
Crawley
West Sussex
RH10 9YX
| Performance:
| m³/h
| l/s
| | Internal motor to create air curtain
| 90
| 25
|
Motor: Asynchronous induction motor with screened poles and thermal protection. Rotor placed on self-lubricating brasses. Motor working with 230Vac, 50Hz at a maximum room temperature of 45°C.
Fan: Centrifugal fan made of thermoplastic, self-extinguishing material V2.
Controls: The complete pulling out of the extractable part controls a micro switch, which starts the motor. A rocker switch controls start the lights.
Ducting spigots: The appliance is equipped with a 125mm Ø exhaust connection, to which the ducting spigot shall be connected with.
Filter: Anodised aluminium filters composed of: Five filtering layers made of anodised aluminium net. Fat absorbing capacity of 75,8% at 572m³/h and 65Pa, in accordance with CEI EN 61591. Anodised aluminium frame. Spring handle made of metal and heat resistant thermoplastic and self-extinguishing material.
Construction: External body made of stainless steel plate AISI 304. Internal parts made of galvanised plate and painted plate.
Sound Levels: Appliance noise level not higher than 44 dB(A) @ 3m.
Mains electrical supply: 230VAC 50Hz.
Power Consumption: 70W.
Complies to the following approvals/directives: CE.
| 
